Video/SAV


SMART Water & SMART Drinks

SUITE Drinks

Frequently Asked Questions

In the event of a power failure, the SUITE machine will automatically go into stop mode. You have to reset the heating. 

For it :
–  Simultaneous pressing of buttons 1 (left) and 2 (middle) for 6 seconds
– The red heating light comes on
– Once warm, the indicator goes blue

The alert for replacing filters has been triggered. To reset it proceed as follows:

  • Turn OFF the machine completely
  • When ON again, all LEDs light up for 3 seconds
  • During this time press button 3 (on the right) for 5 seconds
  • “Filter replace” indicator returns to steady blue

The alert for replacing filters has been triggered. To reset it proceed as follows:

  • Turn OFF the machine completely
  • When ON again, all LEDs light up for 3 seconds
  • During this time press button 3 (on the right) for 5 seconds
  • “Filter replace” indicator returns to steady blue
  • Turn OFF the machine completely
  • When ON again, all LEDs light up for 3 seconds
  • During this time press button 2 (middle) and 3 (right) for 5 seconds
  • Startup procedure is enabled                                                    COMMISSIONINGa) Fill the tank with 3 liters of water. Connect the unit and turn the switch on the back to ON,b) The middle led flashes blue. Make a short press on button 3 (the one on the right). Provide a container because 1 liter of water will be consumed to fill and rinse the filters.c) The middle led flashes red. Briefly press button 2 (the middle one) to fill the water heater. As soon as the LED changes to red, the heating starts. Once the temperature is reached, it will turn blue.PS: If the led “LACK OF WATER” lights up during the procedure, add water to the tank and then make a short press again on the button of the flashing led
  • Press the 1 SET button for 5 seconds
  • Move down in the menu with button 4 (cold) to “ADVANCED SETTING”
  • Enter this menu with the 1 SET button
  • Go down with button 4 (cold) until “SET ENERGY SAVING MODE”
  • Select the mode: NONE = continuous operation, 200 = start with little light, 800 and 1200 = start with more and a lot of light
  • Confirm with the button 1 SET
  • To go up in the menu use button 3 (hot), to cancel use button 5 (room water)